NOTICE: Toggle bolts are not considered an acceptable means of support in Canada, in accordance with CSA C22.2 No. Depending on mounting location, install 4 toggle bolts into drywall or 4 hook screws into wood.Tuck wires inside the driver box and reattach the driver cover.If a 0-10v dimming circuit is available, connect fixture purple wire to driver DIM+ and gray fixture wire to driver DIM. Connect the ground wire with the yellow wire in the driver.Connect white (N) wire with white wire in the driver.Connect black (L) wire with black wire in the driver. Must add pigtail or jumper wires into the ACL and ACN terminal to use a wire larger than 16AWG for both AC and Neutral Line. NOTE: It’s recommended to use 16GA pigtails from the terminal block to the respective power supply wires. Feed the conduit or Romex (based on local electrical code) through the knock-out hole.Remove the driver box cover plate and punch out the knock-out hole.Choose the desired brightness (lumen output). NOTICE: The factory setting for the correlated color temperature (CCT) is 4000K, which is the cool white.Choose your favorite correlated color temperature (CCT) before installing the fixture. Remove existing fixtures and set them aside to recycle in accordance with local requirements.Shut off power at the electrical panel before beginning the installation.Failure to do so can cause serious injury. If uncertain, use cable to support fixture from the retention clips to a suitable support structure. The installer is responsible to ensure grid location is rated for fixture weight prior to installation. Determine the method of mounting before beginning installation. Select a suitable location that can support the weight of the fixture. Surface Mounting Kits – CC DD and EE INSTALLATION
0 Comments
Leave a Reply. |